Visio 2013 stop glue to shape
This is how you select shape-to-shape glue.
ObjType4 turn off Snap to member shapes )if the shape is a group) (ShapeSheet: Group SnapTargetfalse set ueType 8, this works-around the issue where ssangyong korando 2008 ficha tecnica Ctrl Drag duplicates of connectors from glue to shapes despite the proper settings.
For the purposes of this discussion, target refers to the object that has been glued.
It doesnt behave like real-world glue and can be unpredictable.If the endpoint is a large red square, it is glued with dynamic glue.So that's how you change the glue used by connectors.(Just like a macaroni project, where moving the paper moves all the macaroni attached.Select the connector you want to change.Title block information is page-specific, so blocks need to be on the target pages.
By default, shapes snap to both the ruler subdivisions and to the grid.
Visio has hidden controls for connector behavior.Go to: Developer Behavior Placement tab.Make sure the Developer tab is showing.While Visio has settings in the UI for doing this, they dont fully work.Read on, there are two types of glue.Below is a mock-up of a typical case.If youre familiar with Visio ShapeSheets, you can also think of this as all points defined by the Geometry sections of the ShapeSheet.Doing so converts the connector to using shape-to-shape glue.You just drag an endpoint away from the shape, and then drag it back.Make a Tool The main reason I wrote this post is because I keep forgetting what that final setting is (I think Ive written it down in OneNote, but I still have a hard time finding it via search) So I figured I would create.